This will NOT work for replacing the lock body on multipoint lock units. This is a single point lock only. Hoppe Mortise Lock, Manual Gear, Single Point with 1 inch (25mm) Deadbolt throw Used by Caradco, Jeldwen, Norco and others. Stainless face plate 5/8 (16mm) inch wide x 10-7/8 inches long Face plate screw holes are spaced 10-1/8 inch Backset: 2-3/8 inch (60mm) – distance from edge of face plate to center of lock handle All Current Model Single Point Locks from HOPPE w/ Rotation Limiter (Lever is fixed and does not move after door is locked) 11517463. 35mm backset, 14mm deadbolt throw, 16mm faceplate with radius ends 11517475. 35mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends 11517487. 45mm backset, 14mm deadbolt throw, 16mm faceplate with radius ends 11517499. 45mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends 11517505 (this listing) – 60mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends 11517517. 70mm backset, 25.4mm deadbolt throw, 16mm faceplate with radius ends 11517529 – 35mm backset, 25.4mm deadbolt throw, 16mm faceplate with square ends Please contact office. If needing one of the locks not currently linked to our site Latch handing may be changed by pulling out or inserting small screwdriver into small hole in back of latch and pushing forward, twist latch and release. See linked article below. HOPPE Screws for Installation: 8785695. Screw 1-3/8 (35mm) 8mm Head – Stainless Steel 8785687. Screws, 3/4 (20mm) 8mm Head – Stainless Steel Helpful Articles How To Drill Out A HOPPE Mortise Lock If The Dead Bolt Doesn’t Retract. How to Change the Handing (Reverse the Slope of the Latch) on a HOPPE Lock.